[fprint] Upek Touchstrip (147e:1000) new driver problem

[The Source]

  12.09.2010 20:26, The Source пишет:
>  12.09.2010 17:15, Hugo "Bonstra" Grostabussiat пишет:
>>   On 09/12/2010 09:20, The Source wrote:
>>>    Hi, I recentrly installed libfprint-0.3.0 which contains the driver
>>> for specified device. Device is now recognized by fprintd-* commands 
>>> but
>>> I can't make it to recognize my fingers. I create a print with
>>> fprintd-endroll, fprintd-verify gives
>>> Verify result: verify-retry-scan (not done)
>>> in 99% cases. The last 1% is verify-no-match. I noticed that if I get
>>> (not done) the first time it is likely that I'll always get it unless I
>>> restart the program. Has anyone else tested fprintd with this device 
>>> and
>>> had the same problem?
>> Hi, and thanks for your report.
>> I tried to reproduce the bug you encountered.
>> Indeed if you run fprintd-verify and the first swipe fails (e.g. you
>> just tap the sensor instead of swiping) , all subsequent swipes also 
>> fail.
>> However, when I tried to do the same thing with the "verify" program
>> from libfprint, that problem didn't occur. Can you try to do that too ?
>> It would allow to state whether this bug is from fprintd or from
>> libfprint itself.
>> Regards.
>>
>> Hugo Grostabussiat
>> _______________________________________________
>> fprint mailing list
>> fprint at reactivated.net
>> http://lists.reactivated.net/mailman/listinfo/fprint
>>
>
> Err, I guess I'm missing something. I don't have verify executable, 
> only libfprint library. Perhaps Fedora guys didn't include it.
> I'll try compiling from source then. In the meantime, I was able to 
> login to system a couple of times via gdm with fprintd-pam integration.
> But still in most cases I get nasty sound of failure from gdm. I also 
> noticed that with both gdm+fprint-pam and fprintd-verify I get 
> 'not-done' right after I put my finger on the scaner or just started 
> to move it, so I often even don't get a chance to swipe normally.
I downloaded libfprint sources from sourceforge.net. Somehow they are 
0.1.0 pre2 instead of 0.3.0. Compiled lib and examples, enroll program 
can not find my device. Where are the latest sources?